Worked on (the start of) finalizing this amp:
- Mounted transformers properly
- Mounted/installed capacitor board
- Installed RCA jacks for reverb
- Installed 1/4" speaker output jack
- installed power switch (not tight)
- Installed all front panel controls (potentiometers, switch)
- Installed 4 1/4" input jacks
- Installed/connected/soldered front panel controls ground wire
- Installed front panel wiring (shielded multi-pair or single, where appropriate)
- Installed all tube sockets
- Installed ground point at power transformer mounting screw
- Mounted front panel to chassis
- Connected choke wires to capacitor board
- Drilled extra hole in chassis for terminal strip for rectifier circuit
No comments:
Post a Comment